4.
Place the
Corner Belt Rails
on top of the rear corners of the body (they are not side specific). Line the holes in the
Corner Belt Rails with the holes in the body and secure them using
5/16” Torx
® Screws
, 5/16” Flat Washers, and
5/16” Nut Plates
. It is normal to have a gap between the corner and side belt rails. See
Figure 4
and
Figure 5.
5.
Place the
Tailgate Retainer Brackets
inboard of the Corner Belt Rails. The slot with the open end should be oriented
toward the center of the Jeep. Line up the holes in the Tailgate Retainer Brackets with the holes in the body and
secure them using
#10-
24 x 1/2” Phillips Machine Screws
,
#10 Star Lock Washers
,
#10 Flat Washers
,
#10-24
Nylon Locking Nuts
to fasten. See
Figure 6
. If the holes do not line up, enlarge the existing holes or
drill 3/16”
holes in either the body or the brackets, taking care to not drill through any wiring in the body.
6.
To assemble the
Bow Assembly Halves
, lay them on a clean flat surface to identify the front and rear bow (the front
bow will have foam padding). Attach the two halves together using the
Connecter Tubes
by engaging the
buttons in the Connector Tubes with those in the Bow Assembly Halves. The button should pop out of the hole
and lock in place. See
Figure 7.
