RSR TB285SW, User Manual

Page: 8 / 17

8
Installing the Rubber Feet (if using option-B)
You can extend the height of the unit.
Note:
Ensure the surface is clean prior to sticking the rubber foot to the bottom of the unit.
1. Turn the unit upside down.
2. Remove the backing paper from the rubber foot.
3. Stick the rubber foot to the bottom of the unit as shown in the illustration below.
Wall Mounting (if using option-C)
Note:
• Installation must be carried out by
qualified personnel only. Incorrect
assembly can result in severe personal
injury and property damage (if you
intend to install this product yourself,
you must check for installations such
as electrical wiring and plumbing that
may be buried inside the wall). It is the
installer’s responsibility to verify that
the wall will safely support the total
load of the unit and wall brackets.
• Additional tools (not included) are
required for the installation.
• Do not overtighten screws.
• Keep this instruction manual for future
reference.
• Use an electronic stud finder to check
the wall type before drilling and
mounting.
1. Drill 4 parallel holes (Ø 3-8 mm each
according to wall type) in the wall. The
distance between the holes should be
764 mm.
- Firmly fi x 1 dowel into each hole in the
wall if necessary.
2. Tighten the wall mount brackets on
the wall with screws and screwdriver
(not included). Make sure the they are
securely installed.
3. Loosen the screws at the back of the unit for 3 mm. Lift the unit onto the wall mount brackets and
slot into place.
30 inch
(764 mm)
0.08inch
(2mm)
SOURCE
VOL
VOL
30 inch
(764 mm)