RSI SLANT, User Manual, Page: 5 / 7

6 |
ASSEMBLY
INSTRUCTIONS
FEED CORD THROUGH LEG
Route the cord into top and bottom hooks. Gather as much
length as desired in the space between the two hooks.
ATTACH FELT PADS TO TABS
Felt pads will eliminate any rattle that may occur where
cover is attached to leg. At top of leg, place pads into slots
and fold down to overlap.
See Illustration B. Wrap pads
around each of the lower tabs on the cover.
ASSEMBLY INSTRUCTIONS
The assembly of the table frame to be made in accordance with this manual.
Changes to the table frame or improper use may affect the safety, function, and life of your product.
This manual applies to the following table legs: 29 " , 36 " and 42 ".
1
INSTALL LEG ASSEMBLY TO THE TABLE TOP
See Illustrations C–E to choose your preferred configuration.
Mark the locations of the pilot holes. Drill the pilot holes
to the size recommended by the table top manufacturer.
Install the screws through the mounting plate into the table
top. NOTE: The holes in the mounting plate are .13 in
INSTALL COVER PANEL TO LEG
Insert tabs on top of cover panel into corresponding slots of
leg. Slide cover panel downward so that bottom tabs insert
into corresponding slots at the bottom of the foot.
See Illustration A
2
3
4
ILLUSTRATION A
ILLUSTRATION B