DELTA FUSION Owner's Manual
3
RSF Woodburning Fireplaces
SAFETY FIRST
DO'S AND DONT'S
If this fireplace is not properly installed, a house fire could result. For your safety, follow the installation
directions. Contact your local authority having jurisdiction (such as municipal building department, fire
department, fire prevention bureau, etc.) regarding restrictions and installation requirements, and the need
to obtain a permit.
To ANYONE using this fireplace: these
DO's
and
DO NOTs
are for your safety.
1.
DO
read this instruction manual before lighting your first fire.
2.
DO
burn seasoned wood fuel or a combination of densified fuel logs and wood fuel.
3.
DO operate the fireplace with the door fully closed
. If the door is left partly open, gas and flame can be
drawn out of the fireplace opening, creating both fire and smoke hazards.
4.
DO
keep all combustible materials (furniture, firewood, etc.) at least 4' away from the front of the fireplace.
5. This fireplace needs periodic inspection and repair for proper operation.
DO
learn to properly use it and maintain
it.
6. DO
have at least one smoke detector on each level of the house and at least one carbon monoxide detector.
7.
DO
read the section about MOVING THE DELTA FUSION before you begin the installation.
8. To avoid glass breakage,
DO NOT
slam the fireplace door.
9.
DO NOT
ever use gasoline, gasoline-type lantern fuel, kerosene, charcoal lighter fluid or similar liquids to start
or freshen up a fire in this fireplace. Keep all such liquids well away from the fireplace while it is in use.
10.
DO NOT
overfire the fireplace. If you are unable to slow down the burn rate of the fire or if the chimney
connector behind the top louver glows red, you are overfiring the fireplace.
11.
DO NOT
use a fireplace grate or other products not specified for use with this fireplace.
12. The burn rate is set by the automatic air control at the factory.
DO NOT
tamper with the air control.
DO NOT
install a flue damper that would allow you to reduce the chimney draft and thus slow the minimum burn rate.
13. To avoid damaging the fireplace,
DO NOT
operate it in a manner inconsistent with the operating instructions in
this manual.
NOTE:
We strongly recommend that our products be installed and
serviced by professionals who are certified by the National Fireplace
Institute in the U.S. or by Wood Energy Technology Transfer Inc. in
Canada.
CREOSOTE: FORMATION AND REMOVAL
When wood is burned slowly, it produces tar and other organic vapors which combine with the expelled moisture
from the wood to form creosote. The creosote vapors can condense in the relatively cool chimney of a slow burning
fire. When ignited, this creosote makes an extremely hot fire. The chimney should be inspected periodically during
the heating season to see if a creosote build-up has occurred. If a significant layer of creosote has accumulated
(1/4" or more), it should be removed to reduce the risk of chimney fire.
❖
WARNING: BURN DRY WOOD ONLY. DO NOT BURN:
DRIFTWOOD, TREATED WOOD,
COAL, GARBAGE, OR PLASTIC.
Do not use construction scraps (e.g. 2x4 or plywood scraps) as your only supply of fuel as you can overheat and
seriously damage the fireplace. Do not use more than one wax fuel log (e.g. Duraflame) at a time. Use only firelogs
that have been evaluated for fireplace use. In Canada, they should meet the requirements of ULC/ORD-C127-
M1990. Refer to the firelog warnings and caution markings prior to use.
