RS IDM67, Instruction Manual

Page: 22 / 28

21
4-2 BATTERY INSTALLATION OR REPLACEMENT
The meter is powered by two 1.5V batteries. Refer to Figure 2A and use the following procedure to replace the battery:
1. Disconnect the test leads and turn the meter off. Remove the test leads from the front terminals.
2. Remove the holster.
3. Position the meter face down. Remove the screw from the case bottom.
4. Lift the end of the case bottom until it gently unsnaps from the case top at the end nearest the LCD.
5. Lift the batteries from the case top, and carefully disconnect the batteries from the battery connector leads.
6. Snap the battery connector leads to the terminals of the new batteries and reinsert the batteries into the case
top. Make sure that the battery leads do not become pinched between the case bottom and case top.
7. Replace the case bottom. Reinstall the screw and replace the holster.