RS SAILING RS Neo, Rigging Manual

Page: 34 / 47

32
6.2 - Foil Care
6.3 - Spar Care
RS Sailing foils are manufactured from anodised Aluminium extrusions with injection
moulded glass reinforced Nylon ends. Lower mouldings are bonded in with polyurethane
adhesive sealant. Upper mouldings are riveted or screwed in.
Lower mouldings are sealed, however over time there may be some water ingress. If
this occurs foils should be inverted to allow water removal through the drain holes in
the top of the moulding.
Foils contain closed cell foam to ensure buoyancy and limit potential water ingress.
Maintenance
• Foils should be rinsed with fresh water after use.
• Anodising will prevent surface corrosion, however if surface damage does occur the
aluminium should be polished with wax polish e.g. car polish.
• Nylon mouldings are maintenance free and can be sanded smooth if damaged.
• If you run aground hard with the daggerboard down, you should check that the hull has
not been punctured at the front or the trailing edge of the daggerboard case. Special ‘shock
absorbing’ pads have been fitted at these points to reduce the risk of damage, and these can
be replaced if damaged.
If you are going to trail your boat frequently, you may wish to invest in some RS Racing
padded rudder bags. These will protect your RS Neo from any damage caused by the foils.
The mast and boom are made from carbon fibre. Wash with fresh water as often as
possible, both inside and out. Check all of the riveted fittings on a regular basis for any signs
of corrosion or wear.
6.4 - Sail Care
The mainsail and Jib should be rolled and stored dry, out of direct sunlight. When using a
new sail for the first time, try to avoid extreme conditions as high loads on new sailcloth can
diminish the racing life of the sail.
If your sail is stained in any way, try to remove it using a light detergent and warm water. DO
NOT attempt to launder the sail yourself.
A sail can be temporarily repaired using a self-adhesive cloth tape, such as Dacron or Mylar.
The sail should be returned to a sail maker for a professional repair. Check for wear and
tear, especially around the batten pockets, on a regular basis.