Non-Contact Forehead IR Thermometer
Non-Contact Forehead IR Thermometer
12
13
This message displays in various cases – please find below a list
of the main cases
.
Reasons for “
LO
” or “
HI
”
message display
Temperature reading hampered
by hair, perspiration…
Temperature hampered by an air
flux.
The measuring distance is too
far.
From high/low temperature
condition to room temperature
Advice
Make sure that there is no
obstruction prior to taking a
temperature.
Make sure there is no air flux as
this could interfere with the infrared
system.
Please respect the measuring
distance (between 1 to 10cm
– 0.39 to 3.9 in).
Waiting for 10 minutes before
taking the body temperature
14.This appliance conforms to the following standards:
•EN 980: Graphical symbols for use in the labeling of medical devices
•EN 1041:Information supplied by the manufacturer with medical
diveces
•EN 60601-1: Medical electrical equipment Part 1: General requirements
for safety (IEC:60601-1:1998)
•EN 60601-1-2: Medical electrical equipment Part 1-2: General
requirements for safety Collateral standard Electromagnetic
compatibility Requirements and test (IEC 60601-1-2:2001)
EMC Statement
This device has been tested and homologated in accordance with
EN60601-1-2:2007 for EMC. This does not guarantee in any way that
the device will not be affected by electromagnetic interference. Avoid
using the device in high electromagnetic environment.
The MEDICAL DELECTRICAL EQUIPMENT needs special precautions
regarding EMC and needs to be installed and put into service according
to the EMC information provided in the ACCOMPANYING DOCUMENTS.
The manufacturer reserves the right to alter the specifications of the
product without prior notification.
The manufacturer allows himself the right to modify without any
preliminary opinion the technical specifications of the product.
Guidance and manufacturer’s declaration - electromagnetic emissions
The Model Number or Type Number - by manufacturer is intended for use in
the electromagnetic environment specified below. The customer or the user
of the Model Number or Type Number - by manufacturer should assure that
it is used in such an environment.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR11
Harmonic emissions
lEC 61000-3-2
Voltage fluctuations /
flicker emissions
lEC 61000-3-3
Compliance
Group 2
Class B
Not applicable
Not applicable
Table 201 –Declaration - electromagnetic emissions
Electromagnetic environment -
guidance
The Model Number or Type Number
- by manufacturer must emit
electromagnetic energy in order
to perform its Intended function.
Nearby electronic equipment may
be affected.
The Model Number or Type Number
- by manufacturer Is suitable for
use in all establishments other than
domestic and those directly
connected to the public low-voltage
power supply network that supplies
buildings used for domestic purposes.