SOURCE OF POWER
Your Re-chargeable rotary tool has a 9.6V DC motor which makes it safer to use and ensures that the tool is compact and can go
anywhere, without the restriction of cables.
IMPORTANT GENERAL SAFETY TIPS!
1.
The Tool should be switched off when changing accessories.
2.
If you stall the tool, switch it off immediately.
3.
Periodically check the tightness of your collet chuck, especially during prolonged use of the same accessory
4.
After use, always switch off your power tool
5.
Do not undertake repair of the power tool your self.
6.
Do not leave your tool unattended while switched on
7.
Always disconnect the tool from the charger after the 3 hour charge time
8.
Do not undertake repairs on the charger
9.
Do not drop your charger
10.
After charging, always disconnect your charger from the mains
11.
Do not use or store your charger or 9.6V tool in damp or wet conditions.
USEFUL HINTS & TIPS
1.
Your mini tool will become warm after prolonged use and so must be switched off and allowed to cool down.
2.
To ensure smooth running, the spindle should be oiled periodically.
3.
Do not apply too much radial pressure to the accessory bits while polishing, cleaning, sanding or grinding. By doing so you
will put a strain on the spindle and adversely affect the precision of the tool.
4.
Always work with a sensitive touch so as not to impede the efficiency of your mini tool.
5.
When drilling metal, always mark the drilling point with a centre punch first, so that your rotary tool does not slip.
6.
Always ensure that you have maximum contact between the accessory shaft and the collet chuck.
7.
Vary the speed on the tool for the work in hand, eg. Low speed for polishing & cleaning and high speed for engraving
PLACING ACCESSORIES INTO THE TOOL
Always switch the tool off first. Hold the locking button at the front of the tool down and undo the collet chuck (anti-clockwise). Insert the
collet that matches the shaft size of the accessory to be used. Place the collet nut over the collet and then insert the accessory shaft into the
collet chuck ensuring maximum shaft contact. Then tighten up the collet nut. (DO NOT USE PLIERS). To add the LED light adaptor,
simply unscrew black end ring on tool and screw on the LED light. Use little lever switch on light adaptor to switch light on.
KEEP THESE INSTRUCTIONS IN A SAFE PLACE FOR FUTURE USE.
CE Declaration of Conformity
RC09
We declare that this product complies with:
EN55014-1:2000/+A1:2001; EN55014-2:1997/A1:2001; EN61000-3-2:2000;
EN61000-3-3:1995/+A1:2001 ; EN61558-2-6 :1997 ; EN61558-1 :1997+A1 :98+A11 :03
And fulfils the testing requirement of the European Low Voltage Directive (73/23/EEC amended by 93/68/EEC)
and the EMC directive
(89/336/EEC, amended by 93/68/EEC)
This electric mini power tool complies with the E.C. requirements in force relating to radio and TV interference.