6
POLLUTION DEGREE 1
No POLLUTION or only dry, non-conductive POLLUTION occurs.
The POLLUTION has no influence.
POLLUTION DEGREE 2
Normal POLLUTION only non-conductive POLLUTION occurs. Occasionally,
however, a temporary conductivity caused by condensation must be expected.
POLLUTION DEGREE 3
Conductive POLLUTION occurs, or dry, non-conductive POLLUTION occurs which
becomes conductive due to condensation, which is expected.
NOTE :
In such conditions equipment is
normally
protected against exposure to
direct sunlight, precipitation, and full wind pressure,
but neither
temperature
Safety Compliance
And
Certification
Safety compliance
The meter conforms
to CENELEC
LVD (Low-Voltage directive
)
73/23/EEC and EMC
(
Electromagnetic Compatibility directive)
89/336/EEC
The meter meet the requirements of
IEC 61010-1 (2001) , EN 61010-1 (2001),
UL 3111-1 (Jan.1994) , CSA C22.2 NO.1010-1-92 +A2: Feb. 1997
TEST EQUIPMENT RISK ASSESSMENT
Users of this equipment and or their employers are reminded that Health and
Safety Legislation require them to carry out a valid risk assessments of all
electrical work so as to identify potential sources of electrical danger and risk of
electrical injury such as from inadvertent short circuits. Where the assessments
show that the risk is significant, the use of fused test leads constructed in
accordance with the HSE guidance note GS38 “ Electrical Test Equipment for
use by Electricians” should be used.
Safety Compliance And Certification
