- 14 -
M
ICRO
M
AG
-OP-EN
MACHINE OPERATION
PRE-CLEANING CHECKLIST:
Read and understand the Safety Messages section on
Pages 3 and 4 before operating the machine.
1. Check Battery Condition Gauge on the Control Panel.
Make sure Batteries are fully charged before using.
2. Check the condition of the Pads or Brushes.
3. Check the condition of the Squeegee Blades.
4. Raise the Scrubdeck and Squeegee before
transporting then transport the machine to the fi lling
station.
5. Turn the machine
OFF
.
6. Fill the Tank with up to 10 gallons of clean water
either at the front fi ll port
(A)
or rear fi ll port
(B)
(SEE
BELOW)
.
7. Add
APPROVED
cleaning chemical to the Tank.
Use the proper dilution ratio indicated on the bottle.
Contact us at 1(800)-634-4060 or +011-262-681-3583
if unsure.
NOTICE
The clear tube
(Solution Sight Tube)
(C)
at the rear of the
machine indicates the amount of water in the tank
(SEE
BELOW)
.
DANGER
EXPLOSION RISK!
Flammable materials can
cause an explosion or fi re. Do not use fl ammable
materials in tank or pick up.
CAUTION
TO AVOID DAMAGE TO THIS MACHINE:
•
Use approved detergents only
•
Water temperature must not exceed 130˚F/54˚C
•
Do not use high-percentage bleach mixture
OPERATING HINTS:
1. Observe the amount of solution the machine is
dispensing on the fl oor and adjust to the desired fl ow.
To increase the solution fl ow rate, pull the Solution
Control Lever down. To shut the solution
OFF
completely, just release the Drive button, or use dash
mounted switch.
2. Keep an eye on the clear Vacuum Cover to make sure
that there is not any foamy buildup in the Recovery
Tank. If excess foam begins to develop, pour a
recommended foam control solution into the Recovery
Tank. Foam is usually an indication of excessive soap.
3. Always operate at lower speeds when scrubbing
around walls and objects. You should reduce the
speed to maintain control when turning.
4. If squeegee starts to streak, raise and wipe the Blades
with a clean cloth. If the problem continues, check the
Squeegee Blades for wear or damage and rotate if
needed. You may need to pre-sweep before scrubbing.
(Only Use OEM Parts)
5. Change or turn over Pads when dirty.
6. Stay clear of objects protruding from the fl oor such as
sockets, grates, etc, for they will damage the Pads and
Squeegee Blades.
7. Always keep an eye on your gauges. They let you
know the status of a particular system at a glance. If
your Battery Gauge is reading low you much stop
immediately and recharge. Running the batteries dead
will result in damage to the batteries.
8. When you run out of solution, raise the Scrubdeck and
continue to vacuum the remaining water until it is all
consumed. The Solution Sight Tube is used to indicate
the level of detergent remaining in the Tank.
9. When you are ready to stop, raise the Scrubdeck, turn
OFF
the Solution Switch, raise the Squeegee and
drive the machine back to the charging area. Be sure
to drain both Tanks before storing the machine.
A
B
C