RPS Studio RS-RT/04 Series Instructions Download Page 2

Using your Remote Release

• To trigger the camera, depress
the transmitter button slightly until
the LED turns green (The LED will
turn green on the transmitter and
the receiver) This is your prefocus
light. To release the shutter,
continuing pressing the transmitter
button until the LED turns red. The
LED will turn red on both the
transmitter and the receiver.

If the camera is set to the “B”
Position, you can press and hold
the shutter release button for 3
seconds, and the shutter will
remain open. Press it again and the
shutter will close.

Range of Use

The wireless transmitter uses RF (Radio Frequency) waves
to transmit the signal to the receiver.  As a result the
effective distance can vary greatly depending upon the
environmental conditions, including walls, obstructions, etc.
In addition, wireless networks, cell phone towers, and some
cordless phone systems can interfere with the signal. If the
effective range if decreased due to environmental conditions
try another location. This is not considered a defect.
As the batteries weaken, your effective range may 
decrease. Try using fresh batteries.

Deactivating the Unit

• To turn off the power on the receiver, press the orange
button once. The red LED will stop blinking. There is no
on/off power switch on the transmitter.
• If the unit will not be used for some time, remove the
batteries.

Activating the Units

• Extend the antenna on the
transmitter. The transmitter is
activated by the button.  There is
no separate on/off switch on the
transmitter.

•  Activate the receiver by
depressing the pushing the switch
to the on position (towards the
cord). The light will blink rapidly
indicating the unit is starting up.
After that the light will only flash
when it receives a signal from the
transmitter.

• Insert the receiver end plug into
the remote socket of the camera.
Consult your camera’s manual for
its location.

- 3 -

For Canon 5D, 10D, 20D
30D (3 Pin Style)

For Nikon D100, D200
D2X (10 pin Style)

For Canon EOS, Pentax
and other cameras which
use a 3.5 Mini Plug

Please note: Additional models for various
other cameras wiil be released as they
become available.

- 2 -

Green LED Prefocus

Red LED Shoot

Reviews: