RPB C40 Climate Control, Instruction Manual, Page: 13 / 44

13 13
03-022-PMS
03-536
INSPECTION, CLEANING AND STORAGE
C40
™
Climate Control Device
The RPB
®
C40
™
Climate Control Device has a limited service life, and therefore a regular
inspection and replacement program must be conducted. All components of a Respirator
Assembly including the Breathing Air Line, Head-top and Flow Control Devices should be
inspected for damage and wear and tear, before use. Before each use, disassemble the C40
™
to where the clear U-Tube is visible to inspect. If any damaged or worn parts are found, they
should be replaced immediately, or the unit disposed of. Use only parts and components that
are part of the respirator assembly as set out in this instruction manual or that of the head-top.
Refer to the parts list on page 19 for the correct part numbers to replace parts of the C40
™
Climate Control Device. Clean with water and mild detergent or a disinfecting wipe. Dry all parts
and reassemble.
Store the C40 ™ in a cool dry environment with the rest of the respirator assembly, or by itself in
a sealed container or bag outside of the work environment.
Breathing Air Line
Inspect the Breathing Air Line for cuts, cracks, blisters and excessive wear. Ensure the hose
has not been crushed or kinked and that fittings are tightly crimped to the hose so air cannot
escape. Replace the hose immediately if there are any signs of damage or wear.
Do not run water through the inside of the hose. Check Quick Disconnect Couplings and use
compressed air to remove any particles that may jam the coupler.
DISASSEMBLY INSTRUCTIONS
Let the device cool after use before disassembly. The inner components of this C40 ™ Climate
Control Device will become very hot, take care when removing the parts so that you do not get
burned. Allow sufficient time for the device to cool down before dismantling the device.
The first step is to use the Allen key to
unscrew the Swivel Connector (
03-022-
PMS ) from the body of the C40
™
. Unclip the
(03-536) from the C40 ™ (03-502).
1. Push the clip tab on the Exhaust Cover
(03-526) in until it unclips from Exhaust
Case (03-522).
2 . Lift up the (03-526) and
slide it out of the (03-522).
FIGURE 2.1
03-526
03-522
FIGURE 2.2
Clip tab