11
Figure 3
9. Cut and separate the release liner and the film.
(Figure 3)
10. Thread the craft paper behind the Lower Idle Bar to the top film
that is resting on the main roller (do not use the Lower Idle Bar
for Mounting). (Figure 4)
11. Reinstall the Feed Table and the Frame-Paper Guide,and close
the Safety Cover.
12. Adjust the nip setting to appropriate gap.
13. Insert and push the leader board until they reach the front nip
point.
14. Push the Run button.
15. Push the leader board into the rollers. (Figure 5)
16. Adjust the top and bottom tension knob by rotating it clockwise
or counterclockwise. Turn it until the top and bottom roll films
have some resistance (The tension varies depending on the film
thickness; the thicker the film the more tension is required).
(Figure 6)
Figure 4
Figure 5
Figure 6
17. Press the Stop button when the leader board has completely exited from the rollers.
18. Use the Cross Cutter to cut the leader board from the web (see page 9).
19. Set the nip setting to the appropriate position for the Over-lamination / Decaling application.
