RMT Series
9
5. OPERATION
The trimmer must only be used by trained and qualified personnel.
The trimmer must be used only for trimming material for which it has been designed.
For recommended maximum cutting thickness see page 10.
1. The trimmer should be positioned on a level surface in an area with adequate lighting and enough
work space for feeding materials.
2. To begin trimming material, position the material to be trimmed on the front feeding table (Fig. 5-1)
and measure the cut by using the scales present at either side of the feed table or by the guideline.
Do not lean against or put any object on the feeding table during trimming.
Fig. 5-1
Fig. 5-2
6. MAINTENANCE
Standard maintenance
Note:
Only qualified personnel should attempt standard maintenance on the trimmer.
Maintenance Procedures
Follow below procedures as needed.
Maintenance
Frequency of
execution
Procedure
Precautions
General dusting
At user's discretion
•∙Clean∙the∙entire∙machine∙with∙a∙damp∙cloth Do not use aggressive products
Cleaning the scrap
material
If there is a lot of scrap
material
•∙Remove∙the∙safety-cover
•∙∙Eliminate∙the∙scrap∙material∙with∙an∙
aspirator and/or compressed air
Wear a pair of protection gloves