RMF-BC-46SS
5
INSTALLING YOUR BEVERAGE COOLER
Unpacking your beverage cooler
1. Remove all packaging material. This includes the foam base and all adhesive tape holding the
beverage cooler accessories inside and outside.
2. Inspect and remove any remaining packing, tape or printed materials before powering on the beverage cooler.
Leveling your beverage cooler
• Your beverage cooler has two leveling legs which are located in the front corners. After properly placing your
beverage cooler in its final position, you can level your beverage cooler.
• Leveling legs can be adjusted by turning them clockwise to lower your beverage cooler or by turning them
counterclockwise to raise your beverage cooler. The beverage cooler door will close more easily when the two
front leveling legs are extended slightly.
Proper Air Circulation
• To ensure your beverage cooler works at the maximum efficiency it was designed for, you should install it in a location
where there is proper air circulation, and electrical connections.
• The following are recommended clearances around the beverage cooler:
Sides
∙∙∙∙∙∙∙∙∙∙∙
2" (50mm)
Top
∙∙∙∙∙∙∙∙∙∙∙∙∙∙
2" (50mm)
Back
∙∙∙∙∙∙∙∙∙∙∙∙
2" (50mm)
For proper cooling, do not overfill the beverage cooler
Note:
If for some reason the unit was tilted or placed sideways, wait 24 hours before plugging in the beverage cooler
Drip Tray
• Ensure the drip tray in the rear of the unit is in the proper position.
WARNING:
ELECTRICAL REQUIREMENT - SHOCK HAZARD
Electrical Requirement
• Make sure there is a suitable power outlet (115 volts, 15 amps outlet) with proper grounding to power the beverage cooler.
• Avoid the use of three prong adapters or cutting off the third grounding prong in order to accommodate a two prong