RBC-Quickcount
3
Counting function
Connect the adapter to back of unit then plug unit into an outlet. Press --- switch on back to
turn unit on.
888
appears on the led screen and turns to 0 after one second.
Open the protective cover<see figure 1>.
Securely attach the supplied counting guide<see figure 2>.
Once the counting guide is attached to the unit, load the bills into the side hopper. <see
figure 3>. Refer to the label on the side of the hopper panel for proper placement of the bills.
Once the bills have been properly loaded into the side hopper press start to count the bills.
< see figure 4>
The quantity of counted bills will be shown on the screen.
Remove the bills from the stacker and proceed to count the bills again.
NOTE:
counting the same batch of bills more than once is recommended to ensure accuracy.
Addition Function
If you want the unit to perform addition instead of just counting, follow these steps:
1. Count a stack of bills as indicated previously.
2. Remove the counted bills.
3. Place the new stack of bills to count, and instead of pressing the “Start”button, press
the “Add” button.
4. Repeat the previous steps to keep adding bill stacks.
Error messages and troubleshooting
Message
Error
Solution
E-0
Obstruction of the bottom sensor
Clean the sensor and / or the counting wheel
E-1
Obstruction of the top sensor
Clean the sensor and / or the counting wheel
E-3
Bills are not aligned or have been set improperly
Realign and reload the bills and recount
Figure 1
Figure 2
Figure 3
Figure 4
