PRODUCT OPERATION
5
Using the Heater
•
Use the ON/OFF switch on the rear of the heater to power the unit into standby mode.
•
Press the “POWER” button and the heater will switch out of standby mode. The LED display will
show the room temperature. The heater will begin to heat up to the preset temperature of 77°F.
NOTE:
If the room temperature is 2°F higher than the preset temperature, then only the fan will
operate. The heater will switch back on again once the room temperature drops 2° to 3°F.
•
If the heater is not operated for 3 seconds, the LED display will show the room temperature.
•
The heater will cycle on and off to maintain the preset temperature. This is not a fault with the
appliance.
•
To set the heating power, or to use the fan-only mode, press the “MODE” button to cycle through
low heat, high heat, or fan-only settings.
•
To set the temperature, press the
“
TEMP” button to increase to the desired temperature. The LED
display will show the set temperature for 3 seconds.
•
Once the room reaches the set temperature, the heater will cycle on and off to maintain this
temperature.
•
To set the timer, press the “TIMER” button until the desired time has been reached. The LED
display will show for up to 3 seconds, then revert to displaying the room temperature.
Summary of Contents for HCE-220
Page 7: ...LED DISPLAY 7...