1. Please be cautious that neckties, necklaces, long hair and clothing are
kept well away while operating the laminator.
2. Prevent children from accessing the machine.
3. Make certain that the machine is connected to an adequate power source.
4. Do not use for any purpose other than lamination.
1. Width of upper and lower side of film should be same in order not to
allow melted adhesive resin to stick to the rollers.
2. Routine cleaning of rollers is required to prevent adhesive build-up.
3. Always keep the area around the machine clean.
To remove dust, finger prints, etc. from housing, use diluted alcohol
on lint-free cloth and do not permit liquids to get into laminator.
(Do not use strong alcohol or petroleum-based cleaning solvents or
abrasives.)
1. Owner's manual : 1
2. Roller cleaning papeer : (A3) 3 pcs
* Motor doesn't work.
. Power cord may not be
. Check the power cord.
plugged in.
. Power switch is OFF
. Check that the switch is on.
* Film is not laminated.
. Cold mode may be set.
. Change the function to
hot lamination
* Result of lamination
. Temperature on the
. Increase temperature
is not clear.
roller is too low or
or decrease speed.
laminating is too fast.
Check point
Symptom
Cause
IMPORTANT SAFETY CONCERNS
MAINTENANCE
ASSEMBLY PARTS
TROUBLE SHOOTING
17
