BEFORE PLUGGING IN THE UNIT TO A POWER SOURCE:
1. Let the appliance stand upright for about 2 hours. This will reduce the chance of malfunction in
the cooling system from possible mishandling during delivery.
WARNING: The drain cap on the back of the unit may become loose or damaged during
shipping. Fasten the drain cap tightly before you start to operate the unit. If the drain cap is
loose, the unit may leak and cause floor damage.
2. The units water lines must be flushed with fresh water before use. Follow the steps listed
below.
i.
Fill the reservoir with tap water until full. Wait 5 minutes for the water to settle
completely.
ii. Push the hot water button until water begins to come out.
iii. Plug the water dispenser into a grounded power outlet.
iv. Wait for the hot water to come to temperature. About 10 minutes.
v. Wait for the cold water to come to temperature. About 40 minutes.
vi. Unplug the unit. Drain water from spouts until water cooler is empty.
(Note: make
sure to use a large container such as a bucket)
vii. Unscrew drainage cap until all water drains completely.
PRODUCT OPERATION
5
