11
10
Use the smart cap to make mixed juices,
stop juice from dripping, or rinse between
diff erent juices.
After juice and pulp are completely extracted, switch the unit OFF.
HOW TO OPERATE
After preparing the ingredients, plug the power cord into a wall outlet.
Press the FORWARD button to operate.
Insert the prepared ingredients one piece at a time.
• Do not touch the power cord with wet hands.
It may cause electrical shock,
short-circuit, or fi re.
• Check the safety of the wall outlet.
• Forward: Pulls down and slowly masticates the ingredients.
• Reverse: Pushes the ingredients back up to dislodge them.
• Fibrous leafy vegetables (celery, kale, etc.):
» Separate each stem. Cut the outer stems that are thick and tough to 4 inches long or
less.
» Bundle up the leafy vegetables as inserting into the maXtractor™. Alternate between
leafy parts and stems.
• Before extracting, remove hard seeds or pits in ingredients.
• When juicing frozen fruits with small seeds, ensure that even the seeds are completely
thawed.
• Insert the ingredients one piece at a time.
• Align the dots
●
and slide the pusher in.
• After inserting ingredients, use the pusher when it is necessary. Too much use of the
pusher may aff ect the juice quality.
» Intermittently use the pusher for soft ingredients like tomatoes and apples. Constant
use of pusher for soft ingredients may aff ect the juice quality.
• If the remaining ingredients in the juicing bowl have not been extracted completely,
the hopper may not open easily.
After each extraction, run the maXtractor™ for an
additional 30 seconds to let the maXtractor™ extract the remaining pulp.
• When the hopper is stuck, press the REVERSE - OFF - FORWARD button in this order;
switching back and forth 2 or 3 times to dislodge the ingredients. Then place hands
on top of the hopper and fi rmly press down while simultaneously turning it counter
clockwise to open.
» Depending on the ingredients, pour water down the hopper to rinse out the interior
of the juicing bowl and then attempt to remove it.
• Juicing with the smart cap closed creates various mixed juice creations when
diff erent fruits and vegetables, milk, banana, beans etc. are selected.
• After juicing, close the smart cap to stop the juice from dripping, especially when
disassembling the juicing bowl off the base.
• When making diff erent juices quickly rinse away any leftover fl avors by running a
glass of water in the maXtractor™ with the smart cap closed.
• Leave the smart cap open when juicing ingredients that create excessive foam
during extraction, (e.g. apples, celery).
• Pay close attention when operating with the smart cap closed. Juice may overfl ow
if the juice collected in the juicing bowl exceeds its capacity
marked on the bowl.
• REVERSE: Pushes the ingredients back up to dislodge them.
The REVERSE button only works while holding down the switch.
• Switch OFF ensuring that the maXtractor™ comes to a complete stop. Then press
REVERSE.
Hold the REVERSE button for 2-3 seconds and release. Repeat as needed.
Let the maXtractor™ stop completely before using the REVERSE button to prevent
malfunction.
• If the maXtractor™ does not work after these steps, disassemble and clean the
parts before operating the maXtractor™ again.
If the maXtractor™ stops during operation:
Switch the button to OFF position then press and
hold the REVERSE button until the ingredients
become dislodged.
Repeat REVERSE - OFF - FORWARD as needed.
FORWARD : Pulls down the food
OFF : Stops the operation
REVERSE : Pushes the food back up
▶
▶
▶
4
1
3
2
OFF
OFF
REVERSE
FORWARD
Note |
Note |
Note |
Tip |
Note |
Note |
Tip |
Note |
If the ingredients become jammed in the UltraSqueezer™ and the hopper does not open,
press the OFF button. Then press and hold the REVERSE button until the ingredients become
dislodged. Repeat REVERSE - OFF - FORWARD as often as needed to achieve the desired result.
Smart cap
STEP 1
STEP 3
STEP 4
STEP 5
STEP 2
Summary of Contents for Maxtractor
Page 1: ...CARE AND USE MANUAL B77 JM3 HYCITE 1 131107M ...
Page 26: ......
