ROYAL GOURMET HG6000, Owner'S Manual

Page: 14 / 19

13
OPERATING INSTRUCTIONS
Always visually inspect your grill before lighting. Replace any hoses that are frayed or cracked. Look for
anything could block spaces for ventilation and remove it or move the barbecue.
After lighting, check the flame pattern to ensure you have even heat distribution for each burner. If burners
won’t light, or if the flame pattern is uneven, see the Troubleshooting section.
LIGHTING THE MAIN BURNERS USING ELECTRONIC IGNITION
1. Ensure all burner control knobs are in the OFF position.
2. Turn on the propane gas by turning the hand wheel on the cylinder valve.
3. Turn one burner control knob marked with an igniter flame to High.
4. Depress the electronic ignition button and hold down. You should hear a clicking sound, which
shows the electronic ignition is working.
5. If the burner does not light within 5 seconds, turn the burner control knob to OFF. Wait 5 minutes for the
gas to clear, and repeat the above procedure. See the Troubleshooting section, if it still will not light.
6. When lit, turn the control knob to the temperature setting for your food.
MANUALLY LIGHTING THE BURNERS WITH THE MATCH LIGHTING STICK
1. Ensure all burners are in the OFF position.
2. Slowly turn on the gas at the LP tank valve.
3. Place a match in the Match Holder. This is located in the top-centre drawer of the grill cabinet underneath
the right main burner.
4. Use the holder to slide the lit match though the cooking grates and the front of the heat tent to the left of the
burner you want to light.
5. Press and turn the burner control knob to HI/LIGHT. Continue to push in and hold up to 5 seconds or until
the burner lights.
6. If the burner does not light within 5 seconds, turn the burner control knob to OFF. Wait 5 minutes for the
gas to clear, and try again.
7. When lit, turn the control knob to the desired heat setting.
TURNING OFF YOUR GRILL
1. Turn off the gas supply at the propane tank by turning the valve clockwise.
2. Turn all burner control knobs to the OFF position.
WARNING
1. Read instructions before lighting.
2. If ignition does not occur in 5 seconds, turn the burner control(s) off, wait 5 minutes and
repeat the lighting procedure.