Resetting thermal cut-out (TCO)
CAUTION: The thermal cut-out reset switch is located on the back of the device housing.
a)
Disconnect the device from the power supply and allow it to cool down completely.
b) Unscrew the protective lid of the reset switch.
c)
Press the reset switch on the thermal cut-out – you should hear a “click”.
d) Put on the protective lid on the reset switch and screw it back on.
XII. REGULAR CONTROL OF THE DEVICE
Check regularly the device to see if it presents any damages. If there is any damage, please stop using the
device. Please contact your customer service to solve the problem.
What to do in case of a problem?
Please contact your customer service and prepare the following information:
•
Invoice number and serial number (the latter is to be found on the technical plate on the device).
•
If relevant, take a picture of the damaged, broken or defective part.
•
It will be easier for your customer service clerk to determine the source of the problem if you give a
detailed and precise description of the matter. Avoid ambiguous formulations like “the device does not
heat”, which may mean either that it does not heat enough or that it does not heat at all. The more
detailed your information, the better the customer service will be able to solve your problem rapidly
and efficiently!
CAUTION: Never open the device without the authorization of your customer service. This can lead to a
loss of warranty!
EN
6
Rev. 17.03.2021
NOTES/NOTZIEN
7
Rev. 17.03.2021
Error code
displayed
Possible reason
Possible solution
E06
Sensor on heating coil short circuit
please contact your supplier
E07
Sensor on heating coil open circuit
please contact your supplier
E08
overheating of oil temperature (more
than 260
°
C)
please contact your supplier
