(1)
(2)
(3)
(1) Stake
(2) Flatbed
(3) L-Bracket
40mm
40mm
Drill
40mm
4. Seat
Place seat on the seat bearers with the hinges at the back. Make sure it is square
and is able to open freely. Screw to the back panel seat bearer using 4 x 50mm
screws.
50mm
Drill
Drill
6. Coverstrip
Place the coverstrip on the roof apex, Drill 4 holes in each side and secure using
8 x 30mm screws.
30mm
30mm
7. finials
Hold the apex of the roof together by securing an L-bracket using 4 x 40mm
screws to the underside of the front 2 rafters. Use the flat bracket to join the back
2 rafters, secure across the join on the inside of the roof using 4 x 40mm screws.
Drill 2 holes in 4 finials as shown below. Attach finials over each roof and upright
join, 2 on the front and 2 on the back. Drill 4 holes in the remaining finials, position
1 on the front and 1 on the back over the join of the the 2 roof panels at the apex.
Use 4 x 40mm screws per finial. Attach the metal roof to the upright legs using 2
x 30mm screws per leg as shown in the diagram.
Drill
Drill 2 holes in 4 finials
and attach over each roof
and upright join.
Drill 4 holes in 2 finials
and attach at the roof
apex.
2006 © Rowlinson Garden Products Ltd
We constantly improve the quality of our products,
occasionally the components may differ from the
components shown and are only correct at time of
printing. We reserve the right to change the
specification of our products without prior notice.
If in doubt of any aspect regarding the assembly, use or safety of your arbour please contact us :
Help Line (Normal Office Hours) 01829 261121
ROWLINSON GARDEN PRODUCTS LIMITED
Unit 2 Green Lane
Wardle Nr.Nantwich
Cheshire
CW5 6BN
Tel : 01829 262080
Fax : 01829 262089
40mm
Gloves
wear protective gloves while
handling roof sections.
40mm
8. Securing the posts
Place the arbour in the desired location. For a more permanent base fixture use
a metal base fixing.To secure the bottom of the upright posts into the ground use
(1 & 2). If securing to decking or concrete base use metal L-brackets (3).
5. Roof Assembly
Lift the triangular panel into the rebate of the seat back. Lift on the roof panels with
the rebated rafters at the back of the arbour ensure the triangular panel fits into
the rafter rebates. Mark the position of each L-bracket. Remove the roof and
secure the L-brackets to the top of the uprights using 2 x 40mm screws per
bracket. Replace the roof and secure through the brackets into the roof panels
using 2 x 40mm per bracket.
