Before assembly
•
We recommend that time is taken to read the instructions before
starting assembly, then follow the easy step by step guide.
The instruction sheet is only a guide to the assembly.
Certain items may not be shown to scale.
•
Check all components prior to assembly
•
This product should be assembled by no less than 2 people.
•
Some of the components may have sharp edges wear protective work
gloves while handling components.
•
Never attempt to erect the assembly in high winds.
•
Drill all components where indicated.
Recommended tools for assembly
•
Cross head screw driver
•
Drill with 4mm diameter drill bit
•
Step ladder
x 2
Drill
1. Back to uprights
Fit the back panel into the slots of the left-hand upright. Make sure the seat bearer
is on the inside and that the rebated rail is at the top. Secure together by using
3 x 40mm screws, screw through the leg of the upright, ensuring the screw goes
through the rebate in the leg and back panel, secure the seat bearers of the
2 panels with L-brackets and 4 x 40mm screws per bracket. Repeat for the right-
hand upright.
2
1
4
5
6
7
3
8
9
40mm
Seat bearer
Rebated rail
Bottom frame
Upright top frame
Back view
40mm
50mm
2. Seat front and floor
Fit L-brackets flush to the front end of the seat bearer on each upright as shown
using 2 x 40mm screws per bracket. Prior to fitting the seat front, have the floor
in place. Lift the seat front between the uprights. Ensure the top of the panel is
level with the top of the seat bearers and secure with the L-brackets using 2 x
40mm screw per bracket. Fix the panel at the bottom by screwing through the
upright panel into the end of the framing at the bottom of the front panel using
1 x 50mm screw at each end.
50mm
3. Secure the floor
Secure the floor using 4 x 50mm screws, screw 2 through each upright into the
ends of the floor framing,using 4 x 70mm screws, screw 2 through the front and
2 through the back panel into the floor framing.
Important
Have the floor panel in
place prior to fitting the front.
Caution
Some of the building
components may have
sharp edges.
Wear
protective work gloves
while handling these
components.
Gloves
Winchester Arbour
English SS121D
Assembly Instructions
No.
Fixing Kit
Qty.
11
Screws 70mm
4
12
Screws 50mm
10
13
Screws 40mm
62
14
Screws 30mm
16
15
L-brackets 9
16
Flat brackets
1
No.
Components
Qty.
1
Floor 1
2
Seat front
1
3
Left-hand upright
1
4
Right-hand upright
1
5
Seat
1
6
Seat back
1
7
Triangular panel
1
8
Roof sections
2
9
Coverstrip
1
10
Finials
6
Top view
10
50mm
40mm
70mm
50mm
