To VALIDATE the guarantee, this item should be erected on
50mm x 50mm treated wooden or similar bearers (These are
not supplied with the kit.) Ground contact must be avoided.
25mm
25mm
25mm
Drill
3mm
It is recommended to drill
pilot holes for each screw
before assembly.
50mm
Large Panel
Weatherstrip
Small
Panel
Small
Panel
Important
Use this diagram to check the
correct orientation of the corners
Window Panel
Door end
Back P
anel
Back Panel
Side Panel
Panel frames rest on
the floor
Panel cladding
overhang floor edge
50mm
50mm
50mm
Drill
3mm
It is recommended to drill
pilot holes for each screw
before assembly.
50mm
1. Floor
Prepare a level area for the shed to sit. Attach five treated wooden or similar bearers of size 50 x 50 x 1175mm to the floor panel (Not supplied in kit). Position the floor
on the prepared area and ensure level.
2. Opening Window
Lay the window panel on the floor. Fit the hinges in the rebates on the longer edge of the window frame as shown in the diagram using 2 x 25mm screws per hinge, stand
the hinge end of the window on the window panel, making sure it is centred at the top of the window opening. Open the hinges and secure them to the window panel frame
using 5 x 25mm screws per hinge. On the inside of the window panel fit the window stay and its two posts using 6 x 25mm screws as shown in the diagram.
3. Wall panels
Position a large panel and a small side panel on the floor as shown. Note how the panel frames sit on the floor with the panel cladding overhanging the floor edge. Ensure
square and secure using 3 x 50mm screws, screw through the frame of the small side panel into the frame of the back panel. Continue to add the remaining panels in the
same way, in the order shown below.
4. Apex panels
Place an apex panel on top of the back panel and secure using 2 x 50mm screws, screw up through the top frame of the back panel into the bottom frame of the apex panel.
Attached the front apex in the same way. Fix to the frame of the front apex, the door header rail using 2 x 50mm screws. Secure it flush to the bottom of the apex framing.
Fix the weatherstrip to the apex panel above the door, use 3 x 50mm screws. Screw through the frame of the apex panel into the weatherstrip.
Door header rail
Important
Note the floor framing at one end. This
must be positioned at the door end of
the shed.
25mm
Black
