2. Seat back to uprights
Drill four holes in the frames of the seat back as shown in the diagram. Place the seat back on the seat between the
two uprights. Secure through the drilled holes into the legs of the uprights using 4 x 60mm screws. From the front of
the arbour, screw 1 x 60mm screw through each of the seat back frames into the seat frames.
Drill
Drill
60mm
360mm
Drill
60mm
60mm
Important Note:
Ensure rebate slots for
back panel are on the
inside at the back.
Drill
1. Seat to uprights
Drill four holes in each of the seat frames as shown in the diagram. Position the seat between the two uprights,
360mm from the bottom of the upright. Secure through the drilled holes into the upright legs using 8 x 60mm screws.
