1. Seat back to uprights
Fit the back panel into the slots of the left-hand upright. Make sure the seat bearer is on the inside and that the
rebated rail is at the top. Secure together by using 3 x 40mm screws, screw through the leg of the upright, ensuring
the screw goes through the rebate in the leg and back panel, secure the seat bearers of the two panels with
L-brackets and 4 x 40mm screws per bracket. Repeat for the right-hand upright.
4. Seat
Place seat on the seat bearers with the hinges at the back. Make sure it is square and is able to open freely. Screw to
the back panel seat bearer using 4 x 50mm screws.
3. Secure floor
Secure the floor using 4 x 50mm screws, screw two through each upright into the ends of the floor framing. Using
4 x 70mm screws, screw two through the front and two through the back panel into the floor framing.
2. Seat front and floor
Fit L-brackets flush to the front end of the seat bearer on each upright as shown using 2 x 40mm screws per bracket.
Prior to fitting the seat front, have the floor in place. Lift the seat front between the uprights, ensure the inset top
frame is at the top see below diagram. Ensure the top of the panel is level with the top of the seat bearers and secure
with the L-brackets using 2 x 40mm screw per bracket. Fix the panel at the bottom by screwing through the upright
panel into the end of the framing at the bottom of the front panel using 1 x 50mm screw at each end.
40mm
Seat bearer
Rebated rail
Bottom frame
Upright top frame
40mm
Top view
40mm
50mm
50mm
50mm
70mm
50mm
50mm
6. Coverstrip
Place the coverstrip on the roof apex, Drill four holes in each side and secure using 4 x 30mm black screws and
4 x 25mm black screws as shown below.
25mm
40mm
40mm
40mm
Gloves
wear protective gloves while
handling roof sections.
5. Roof assembly
Lift the triangular panel into the rebate of the seat back. Lift on the roof panels with the rebated rafters at the back of
the arbour ensure the triangular panel fits into the rafter rebates. Mark the position of each L-bracket. Remove the
roof and secure the L-brackets to the top of the uprights using 2 x 40mm screws per bracket. Replace the roof and
secure through the brackets into the roof panels using 2 x 40mm per bracket.
Drill
Drill
40mm
Important Note:
Front panel orientation. It is
important that the front
panel when in place has the
inset frame at the top to
allow for the seat to close
properly.
Inset top
frame
Bottom
frame flush
with cladding
End view of front panel
Important
Have the floor panel
resting in place as the
front panel is fitted.
