1. Outer track runners
To the underside of both outer tracks components, insert five runners into the metal tracks.
2. Tracks to legs
Position a leg on the ends of each track section. Note that the centre leg is fitted to the centre track and the outer legs fit to the outer track sections, ensuring that the
rebate in each of the outer leg faces inward. For each leg make sure it is pushed up against the ends of the metal track section and right angles to the tracks, drill using a
10mm drill bit, through the leg and timber of the track sections and secure using 2 x 115mm bolts nuts and 10mm washers per leg. Fit the cleat to the inside of the front
middle leg where the pulley chord hangs down, position so that the chord can be wrapped around the cleat when not in use. Secure the cleat using 2 x 40mm black
screws.
Drill hole for the bolts in
diagonally from each other.
Metal track insert
Timber track frame
Leg
115mm
Washer
10mm
Nut
40mm
black
x5
x5
Ensure the leg is pushed up
against the end of the metal track
and that the leg is square with
the timer frame.
Important
