Panel frame
Floor
Back panel
Side panel
3. Securing the walls to the floor
Ensure the panels are sitting square on the floor. Secure using 16 x 65mm screws, screw through the panel frames and floor into the floor bearers.
50mm
Floor joists
Floor
Panel frames
rest on floor.
50mm
panel cladding
overhangs floor
edge.
It is recommended to drill pilot holes
with a 4mm drill for each screw.
Drill
Side panel
F
ront panels
Large plain panel
Large plain panel
Small plain
panel
Window panel
Back panel
Important Note:
Ensure correct orientation
of front panels. Make sure
the rebate edges face
inward for the door to fit in.
Large plain panel
Large plain panel
1. Laying the floor section
Prepare a level area of no less than 1870 x 2450mm for the shed to sit. To the bottom of both floor panels, attach the short floor bearers flush with the short edge of the
floor using 5 x 30mm nails, nail through the floor panel into the bearers. In the same way attach to each floor panel five long floor bearers between the short bearers as
shown using 8 x 30mm nails per bearer. With the two floor panels upside down, join together using 5 x 50mm screws.
50mm
50mm
30mm
Assembly tip.
The window panels
can be interchanged
with any of the
large panels on the
side or back of the
building.
2. Fixing the wall panels together
Position a large panel and the small panel as shown. Note how the panel frames sit on the floor with the panel cladding overhanging the floor edge. Ensure square and
secure using 3 x 50mm screws, screw through the frame of the small panel, into the frame of the large panel. Continue to add panels as shown below securing each one
with 3 x 50mm screws. It is important to note that the front panels must be orientated correctly so that the framing creates a rebate for the door to fit in.
293mm
293mm
293mm
Important note
To
"VALIDATE"
the guarantee, adequate provision must be made to ensure ground contact is avoided and air
is able to circulate underneath the building.
Placing the building on a concrete pad or slab base is acceptable provided that the building is not allowed to sit
in pooled water during wet conditions.
If the building is to sit on soil or grass it
MUST
be erected on additional pressure treated wooden 50mm
x 50mm or similar bearers
(These are not supplied in the kit).
Rowlinson Garden Products recommend using pressure treated bearers with all buildings on any type of base.
293mm
63mm
63mm
63mm
