50mm
Drill pilot holes with a 3mm drill bit for all
screws in this section.
3mm
Drill
50mm
Roof centre block and inside capping
Side view
End view
Assemble component
Important note
Ensure roof block assembly is
sitting level and support this
end securely with a prop.
50mm
5. Roof part 2
Lift on the the left and right-hand glazed roof panels. Add a bead of silicon down the edge adjoining the solid roof panels and secure to the roof sections using 2 x 50mm
screws per panel.
View from inside the potting store looking up
Drill pilot holes with a 3mm drill bit for all
screws in this section.
3mm
Drill
40mm
6. Roof part 3
Position the triangular roof panels as shown, loosely secure them together using 2 x 50mm screws per join as shown. Adjust the roof panels to achieve the best fit. Add a
bead of silicon between each roof panel then fully tighten the screws.
Drill pilot holes with a 3mm drill bit for all
screws in this section.
3mm
Drill
View from inside the potting store looking up
Important note
Add a bead of silicon down the
edge of each panel before
finally securing together.
Important note
Secure panels loosely and
adjust to achieve best fit.
Add a bead of silicon
down the edge of each
panel before finally
securing together.
4. Roof part 1
Build the two large roof sections using the four solid roof panels by joining the panel frames together, ensure the frames are flush with each other and secure using 2 x 50mm
screws for each panel join. Assemble the roof centre block with the internal roof capping, have the block sitting central on the cap except at the flat end where the two
components should be flush with each other. Secure the capping to the centre block using 8 x 50mm screws. Screw through the cap into the block. Insert the flat end of the
roof block assembly into the apex, secure using 2 x 50mm screws. screw up through apex frame into the roof block assembly. ensure the roof block assembly is sitting level
and securely support the other end using a prop. When the block is secure and fully supported lift on the two roof sections and secure to the walls panel using 6 x 40mm screws
per side.
50mm
50mm
50mm
50mm
Make sure the two
components are
flush at this end.
Apex P
anel
