background image

1. Metal post stands

Slot a metal post stand on to the bottom of each leg of the 2 uprights, ensure the upright legs go all the way to the bottom of the metal stands. Using a 10mm drill bit,
drill 2 holes in each upright leg using the holes in the metal post stands as guides. Insert a 90mm bolt through each hole, to the threaded end add a washer followed by a
nut.Tighten the nut using a 13mm spanner.

90mm

90mm

3. Secure chain support brackets

For the position of the  chain support brackets, measure from the inside edge of the upright 40mm, position the chain support and fix in place using 1 x 6mm dia. x 40mm
screw per support bracket.

2.Top rail

Onto each end of the top rail slide a chain support bracket. position the top rail on the top of the 2 uprights between the pre-fitted centre metal l-brackets. have the the
ends of the top rail flush to the outside edge of the upright. Secure the top rail in place using 4 x 40mm screws per bracket.

40mm

40mm

40mm

40mm

40mm

Front view

Position the chain support brackets

40mm in  from the uprights.

Note: Ensure that the 6mm diameter
40mm long screws are used to secure the
chain support brackets.

10mm

Drill

10mm

Drill

Summary of Contents for Dartmouth

Page 1: ... 4mm diameter drill bit 10mm diameter drill bit 13mm spanner Step ladder x 2 Drill No Components Qty 1 Bench back 1 2 Bench seat with shaped front rail 1 3 Bench arm left 1 4 Bench arm right 1 5 Uprights 2 6 Top rail 1 7 Front right back left angled braces 2 8 Front left back right angled braces 2 9 Corner supports 4 10 Roof sections 2 11 Coverstrip 1 12 Metal post stands 4 13 Chain support bracke...

Page 2: ... brackets measure from the inside edge of the upright 40mm position the chain support and fix in place using 1 x 6mm dia x 40mm screw per support bracket 2 Top rail Onto each end of the top rail slide a chain support bracket position the top rail on the top of the 2 uprights between the pre fitted centre metal l brackets have the the ends of the top rail flush to the outside edge of the upright Se...

Page 3: ...th the short rebate as shown below Position each brace so that the large rebate sits on top of the upright and the small rebate is under the top rail Secure the braces in place using 6 x 60mm screws per brace 60mm 60mm Large rebates Small rebates 40mm 6 Roof Lift the assembled roof onto the uprights having the pre fitted metal L brackets on the uprights inside of the roof Ensure the rebates in the...

Page 4: ...ch Note Have the long angled ends to the roof rafters and the short angled ends to the uprights Hard surface If the link is to small tap the link gently with a hammer to expand Hook the middle link of a length of chain onto the chain support bracket Attach the ends of the chains onto the seat hooks Adjust the height and angle of the seat by using different links in the chain Important note Compone...

Reviews: