9
3
4
5
6
7
8
16
10. Make sure the entire cylinder cover assembly is intact, all
the parts are on, including compressed spring (3), rectangle
washer (4), cylinder cover (5), O-Rings (6 & 7), piston stop
(8) and sealing gasket (17). Place the cylinder cover
assembly on as shown
(Fig. 26)
.
Fig. 26
11. Place the exhaust cap on as shown
(Fig. 27)
.
12. Insert the four bolts. Tighten the bolts while
pressing down the exhaust cap. Connect the stapler
to the compressed air. Try to shoot a few staples.
Make sure there is no air leak.
Fig. 28
Fig. 27
Cylinder Cover
Assembly
8. Make sure the new washers are clean, free of any
debris or cracks. Apply lubricant grease
(AS65)
around the outer edge of the new rubber washer.
First place the new rubber washer, then the metal
washer on the stapler and make sure the washers are
oriented properly (See
Fig. 24
).
9. Replace the magazine/nose assembly as shown. Take
care to line up the piston blade with the slot in the
magazine/nose assembly. Be careful not to bend the
piston blade. Do not force! Replace and tighten the
three screws as shown below.
Fig. 24
Grease
Fig. 25
