background image

To obtain the best results with your LISSIMA dryer, read the instructions and safety precautions 
carefully before using. 

• 

“Ultra-liss system with Ceramic”

This exclusive system allows you to smooth your hair and to dry it

gently in a single step. The Ceramic technology leaves your hair shiny and glossy, while protecting the hair fibre.

• 

"IONIC" SYSTEM : 

When you press the “Ionic” button, your appliance will automatically emit negative ions

that dispel static electricity. You hair will shine and be easier to untangle.

2. SAFETY RECOMMENDATIONS

- Ensure that the voltage of your electrical installation corresponds to that of your appliance. Incorrect connection
may cause irreversible damage which will not be covered by the guarantee.
- Don’t use your appliance  and contact a service Centre if:

- your appliance is dropped
- if it doesn’t work normally

- Never use the dryer with wet hands or near water in a bath, washbasin or any other recipient.
- If the hair dryer is used in a bathroom, disconnect after use since water can present a danger
even when the hair dryer is not being used.
- The dryer must be disconnected:

- before cleaning and maintenance.
- in the event of a malfunction
- as soon as you have finished using it
- if you have to leave it unattended, even for a few moments.

- To ensure additional protection, we recommend that you have a differential residual circuit breaker installed, with
an operating differential of no more than 30 mA. Contact your installer for advice.
- If the power cable is damaged, it must be replaced by the manufacturer, its after-sales service or a person with
similar qualifications to avoid any danger.
- If the power cable is damaged, it must be replaced by the manufacturer, its after-sales service or a person with
similar qualifications to avoid any danger.
- The dryer is equipped with a heat-sensitive safety device. In the event of overheating (for example if the rear grill
is blocked), the dryer will stop automatically: contact the After-Sales Service.

GUARANTEE

This appliance has been designed for a domestic use only. It can not be used in any professional apllication. 
The guarantee becomes null and void in case of incorrect use.

3. RECOMMENDATIONS FOR USE

FITTING AND REMOVING ATTACHMENTS:

Place the attachment (STRAIGHTENER or CONCENTRATOR) onto the dryer, with the notch at the top (Fig. 1). Push
gently until the attachment clicks into place (Fig.2).

To remove:

press on the buttons (Fig.3) to remove the attachment.

SPEEDS:

LISSIMA has 2 heat/speed settings†(Fig.4):  
- Level " 

1

" : average airflow and heat to style your hair (ideal

for a perfectly smooth result).
- Level " 

2

" : faster airflow, ideal for drying your hair fast.

“IONIC” SETTING:

• Slide the “Ionic” switch forward: the button will light up, indica-

ting that the Ionic function is active. The static electricity in your

hair will be reduced (fig.5).
• To desactivate the Ionic function, simply slide the switch back again.

GB

1

2

3

4

5

NOT CV9020 - 011425 1-29  3/01/05  13:47  Page 12

Summary of Contents for LISSIMA 011425 - 49/04 CV9020










Reviews: