5
USING FOR THE FIRST TIME
왎
Please read the instructions for use and the
Important Safety
instructions
carefully.
왎
It is normal for a small amount of smoke to be produced the first
time the appliance is used. This will quickly disappear.
왎
When the appliance is plugged in, and
thermostat control dial is moved from
the minimum setting, the soleplate
heats. Do not touch or remove the sole-
plate cover without letting the appliance
cool down.
왎
During use or while unit is heating or
cooling, do not rest appliance on its sole-
plate. Place product on its side on a firm,
heat resistant, flat surface, as soleplate
will be hot.
왎
As the appliance heats the housing becomes warm.This is normal.
DUAL VOLTAGE
Dual voltage selection
왎
The appliance can work on both, 120V
or 240V, AC systems.
왎
Be sure the dual voltage selector (E) is in
the correct voltage position before oper-
ating. To do this, unplug the appliance
and turn the selector which is below the
handle with a coin, so it is aligned with
the correct voltage (either 120V or 240V).
Never change selector while unit is plugged in.
왎
This is a 120/240 V dual voltage appliance and may be used in the
United States and abroad without an electricity converter.
An adapter plug may be necessary when using appliance in foreign
countries. If needed, plug the steambrush into correct adapter plug
for the specific country and plug assembly into electrical outlet.
Dual voltage selector in wrong position
왎
If the voltage selector is set to 240 V in a 120 V supply, the
performance of the Steambrush will be reduced.
왎
Never set the voltage selector to 120 V in a 220–240 V supply, as
this can damage the product.
FILLING THE WATER TANK
Before plugging in the Steam 'n Press fill the water tank (C) with water
as follows:
Remove the water tank
왎
To remove the water tank, hold on to
the bottom half of the handle and slide
the top half of the handle away from
the appliance as shown.
120 V
240 V
!
