Rowe Scan 600-20, Operating Manual

Page: 27 / 140

28
3.1 Position of ON / OFF Switch
The scanner is switched ON by a toggle switch at the back of the device. The switch is
located above the mains plug (see Figure 3.1). If the device is switched ON, the operating
LED under the green button (2) on the control panel (see Figure 3.2) lights up.
During the installation process switch scanner ON only after being prompted
to do so.
The scanner works properly only after
installation of the ROWE Scan 600 software
(see Chapter 2) prior to use.
Set the switch to position "O" to switch the
device OFF.
Set the switch to position "I" to switch the
device ON.
Figure 3.1: Position of ON / OFF switch
On the control panel of the scanner (also see Figure
1.2 on Page 13) you see two LEDs. After having
switched ON the device, the operating LED under
the green button (2) lights up.
Should a failure occur (e.g. paper jam), the LED
under the red button (1) lights up.
If the operating LED under the green key (2) is
flashing, the scanner is in
energy saving mode . In
this mode, the scanner is not recognized by the PC.
In order to put the scanner into operation again,
simply press the green button once.
If you do not use the scanner for a longer
period, pull the mains plug.
Figure 3.2: Control panel