Rowe Scan 600-20, Operating Manual

Page: 14 / 140

15
Component Minimum requirements Optimum requirements
Interface High Speed USB (2.0) Super Speed USB (3.0)
Operating system Windows XP SP3 (32 bits) Windows 7 (32 bits)
Screen Size: 17"
Resolution: 1,280 x 1,024
Size: > 19"
Resolution: > 1,280 x 1,024
Touch screen
(optional)
Size: 17"
Resolution: 1,280 x 1,024
Size: > 19“
Resolution: > 1,280 x 1,024
Table 1.3: PC requirements for operation of ROWE Scan 600 software
For installation of the ROWE Scan 600 software on your PC, administrator
rights are required.
In exceptional cases, a USB 2.0/3.0 host controller chip set may not be
compatible with the high performance transfer mode of the ROWE Scan 600.
We recommend to use hardware meeting these requirements. A current list of
compatible USB chip sets is available on request.
1.6 Connection of ROWE Scan 600 to Power Supply
Before using ROWE Scan 600, connect the scanner to the power supply. Put the plug of
the scanner into a socket. Please absolutely observe the following:
The scanner must only be connected to a grounded socket with VDE
homologation.
The socket has to be protected by fuses (10 A).
When several devices are connected to one socket using an extension cord
and / or a multiple socket, the total current draw shall not exceed 10 A.
The socket has to be located near the scanner.