20
6.
Pings
a.
Number of pings collected during the ensemble.
7.
Good
a.
Number of good pings in the average. Good = meet or exceed the
selected signal to noise threshold (Thres).
8.
Beg(m)
a.
Start location of the volume average.
9.
End(m)
a.
Last location of the volume average. The End location will be
adjusted towards the Begin location if the signal to noise level is low.
Figure 10. Volume Tab in RTI HASCP software
10.
Thresh(dB)
a.
Signal to noise threshold for good data.
11.
S0(dB)
a.
Average noise level in the volume measurement.
12.
N0(dB)
a.
Average noise level during the measurement.
13.
Pings ( second beam of Janus pair)
a.
Number of pings collected during the ensemble
14.
Good( second beam of Janus pair)
a.
Number of good pings in the average. Good = meet or exceed the
selected signal to noise threshold (Thres).
15.
Beg(m) ( second beam of Janus pair)
a.
Start location of the volume average.
16.
End(m) ( second beam of Janus pair)
Summary of Contents for HASCP
