Nissan GT-R R35 Electric Ride-On Car
9
Assembly
CAUTION!
Children may be harmed by small parts,
sharp edges and points or electrical components when
the vehicle is unassembled. Care should be taken to not allow
children near parts when unpacking and assembling the vehicle.
1. Install the rear (driven) wheels.
•
Place each rear wheel (
A
) on to the axle, with the drive teeth (
B
) facing inward. Press the button (
C
)
in, then push the wheel into position and release the button.
•
Align a wheel cover (
D
) so that the locating tabs (
E
) are aligned with the slots in the wheel, then push
the cover down onto the wheel until all tabs are located in the wheel and it “snaps” into place.
2. Install the front wheels.
•
Place each front wheel on to the axle. Press the button in, then push the wheel into position and
release the button.
•
Align a wheel cover so that the locating tabs are aligned with the slots in the wheel, then push the
cover down onto the wheel until all tabs are located in the wheel and it “snaps” into place.
3. Install the steering wheel.
•
Remove the screw and nut from the steering wheel stem. Plug the vehicle and steering wheel
electrical connectors (
F
and
G
) together. Feed excess wire into the steering column housing (
H
).
•
Ensure the front wheels are straight then slide the steering wheel stem (
J
) onto the steering shaft (
I
)
– ensure that the steering wheel stem screw hole aligns with the hole in the shaft.
•
Insert the nut (
K
) into the recess in the steering wheel stem. Insert the screw (
L
) from the other side
of the steering wheel stem, passing through the steering shaft and into the nut. Adequately tighten
the screw with an appropriate screwdriver.
A
C
B
E
D
G
J
F
H
I
K
L
Video Tutorial: