21
ROVERS NORTH, INC. 1319 VT ROUTE 128, WESTFORD, VT 05494 USA www.roversnorth.com (802) 879-0032
RNGWK90
DEFENDER 90 WOOD MODEL PARTS KIT
1
/
18
th
SEMI-SCALE
REALISTIC DISPLAY
Install Roof, Exterior Parts
Test fit the roof center part to the roll bar and top of rear
door body. Make sure that all roof panels are
etched side
facing out
. Add glue to center of roll bar slot and top of rear
door body.
TIP:
I noticed that there is some air space between the
roof parts. No problem, this is where the GEL super glue ex-
cels and fills extra voids.
Test fit the front roof panel, glue down as indicated to top
of windscreen and front of center roof panel.
Test fit each side roof prior to gluing. Fill air gap voids
with GEL Super Glue as needed. Don’t use too much, but use
enough to bond the parts well.
Locate the front bumper parts. The large piece fits on
first, a smaller bumper piece, then the brush guard fits into
17
A
B
C
D
the chassis slots. Test fit all of these first before gluing, adjust
as needed and slide over chassis tabs as shown above.
TIP:
If you purchased the D90 Roof Rack kit, this
includes a brush guard with rallye lights, use this instead.
The front brush guard didn’t fit into the chassis hole slots all
that well and I chose to notch with the file to fit. Sand the
large bumper and small bumper piece surfaces as this will
provide more clearance to mount the brush guard into the
slots. I recommend both modifications to help mount the
brush guard into the slots, see (17D). Align the top of the
brush guard a tick lower than the top of the bonnet base as
shown.
Test fit all remaining door handles, rear door handle and
raised air intake before gluing, adjust slots and holes as
needed with file. Mount as shown in photo, glue where indi-
cated.
- Roof Top Center x1
- Roof Top Front x1
- Roof Top Sides x2
- Exterior Bits (mirrors x2, handles x3, raised air intake x1)
E
