Roverpet
20 Kiji Dava Circle Prescott, Arizona 86301
1-800-658-5925
Page 2 of 3
7.) Assemble the puppy rails by inserting the cross-bars into the through-drilled holes in the main bars and
then insert the four legs into the blind holes drilled into the bottom of the main bars; be sure to orientate the
main bars so that all four blind holes are facing the same direction. Refer to the three photos below for
visual clarification.
8.) Insert the Roverpet puppy rail assembly into the Roverpet whelping box with the drilled and end-notched
leg bars running across the door opening for correct fastening orientation, as shown in the left photo below;
partially engage the two notched ends of the leg bars with the second inward-most vertical bars of the #118
panels as shown in the right photo below.
9.) Proceed with lowering the Roverpet puppy rail assembly into the opposite side of the Roverpet whelping
box and completely engage the notched ends of the leg bars with the small vertical bars of the #118
panels. Supporting the small vertical bars with one hand while simultaneously pushing the leg bars towards
the #118 panel with your other hand will help to more easily facilitate the connection. Refer to the two
photos below for visual clarification.
10.) Once fully engaged with the vertical bars of the #118 panels, push the Roverpet puppy rail assembly
completely to the bottom of the Roverpet whelping box and seat it against the floor trays. Install the 2
#PRS66 Support arms
11.) Starting on the right side of the #D18 door (looking from the outside of the whelping box),feed the #DPK
Designer Puppy Keeper, with the label side facing out, between the large outer pipe of the door frame and
the small diameter vertical bar adjacent to it (left photo below). Feed the fabric across the back of the door
and pull it back through the same position on the other side of the door (right photo below).
12.) Return the end of the fabric back inside the Roverpet whelping box by routing it around the outer frame
pipes of the #D18 door and the #118 panel connected to it (left photo at the top of the next page). Run the
fabric down the inside of the panel and pull it back outside of the Roverpet whelping box between the 2
nd
and 3
rd
small diameter vertical bars from the corner (right photo at the top of the next page).
