Kali-Ko Kathouses 20 Kiji Dava Circle Prescott, Arizona 86301 1-800-658-5925
Step 3:
Secure the #F26 shelves in place with the #S31 shelf support braces.
Each shelf will have (2) #S31 support braces attached. The two braces will go
approximately 2 ft. to the left and right of the center of the shelf. Snap on the
brace with the ‘cap’ connecting to the shelves outside pipe and the angled part of
the brace connecting to the lower panel. Secure as shown in figure 2 below (
also
shown from the underside of the shelf
).
Fig 1
Fig. 2 Fig. 3
Step 4:
Place the (3) #C72C (lid) on top of the enclosure, making sure the
#200 panel clips are facing down. Walk around the enclosure, snapping the
#200 panel clips on as you go around. Make sure the lids are centered, and
‘even-up’ any sides that are sagging.
Step 5:
If you purchased a floor with wheels it will consist of (2) #F26W pre
drilled floors. Place the floors in the enclosure with the pipe side up (flat side
down) and attach (4) #250 floor divider clips where the floors come together,
spacing the clips evenly apart. Next, take (12) #250 floor divider clips and attach
one per 2 ft. section of enclosure panel, attaching the clip in the center of the
panel to the floor’s pipe (see figure 3). You do not have to clip the floor to the
enclosure (for ease of sliding the floor out for cleaning) however the enclosure is
more stable with the floor attached. The door panel may now be connected with
the panel to its right.
*NOTE: An enclosure should never be used outside without a floor attached.
Congratulations! You are now ready to use your Kali-Ko Kathouse #K666W enclosure.
Property of Kali-Ko Kathouses, Div. of Rover Company
WWW.ROVERPET.COM