Roverpet 66PR Assembly Instructions Download Page 2

Page: 2 / 3

Roverpet

20 Kiji Dava Circle Prescott, Arizona 86301

800-658-5925

[email protected]

Page 2 of 3

3.) Insert one end of the

#72

CB’s into the large holes located near the ends of

(1)

#PR72LB. Slide the #72CB into the hole

until about 4” is protruding through.

4.) Install the remaining

(2)

legs into the #PRS66 leg hole. Install one on each of the #72CB. Slide the #PRS66 onto the

#72CB until centered on the #72CB. When installing the #PRS66, verify the legs of the #PRS66 are positioned the same
as the legs of the #PR72LB.

5.) Install the second #PR72LB onto the two remaining ends of the #72

CB’s, using the same method as before. Make

certain that all 4 legs installed in Step 2 are positioned in the same direction.

6.) Take the assembled Roverpet Puppy Rail System and lower one side of the rails into your Roverpet whelping box. Line

up the #PR72LB connecting ends with the 2nd vertical bars of the whelping box panels.

Note:

Make sure the #PR72LB connecting end will not be installed on a door panel, rotate the Roverpet Puppy Rail Assembly

90* to avoid attachment on door panel. Verify the legs will rest on the floor of your whelping box when installation is complete.

Vertical Bars

Summary of Contents for 66PR

Page 1: ...ered Assembly Procedure Special Notes If your Roverpet 6 x6 whelping box consists of a door panel it needs to be configured with the door located on the right or center of the whelping box side to all...

Page 2: ...he legs of the PR72LB 5 Install the second PR72LB onto the two remaining ends of the 72CB s using the same method as before Make certain that all 4 legs installed in Step 2 are positioned in the same...

Page 3: ...ush the whole Roverpet Puppy Rail System down until all four legs are resting on the whelping box floor 10 Attach the PRS66 connecting ends to the middle of the center whelping box panels If your Rove...