12
Fig. 2
Washer
Bolt
Wing Nut
INSTALLING AND REMOVING THE ATTACHMENT
The coupler enables the use of various optional attachments.
Installing the Attachment
1. Remove the hanger cap from the attachment. Keep the hanger cap for use when storing the
attachment. If present, remove the gray spacer from the coupler.
2. Set the unit on a flat, level surface.
3. Turn the knob counterclockwise to loosen the coupler (Fig. 3).
4. Align the release button with the guide recess (Fig. 5).
5. Push the attachment straight into the coupler (Fig. 4) until the release button snaps firmly into the
primary hole (Fig. 5).
6. Turn the knob clockwise to tighten the coupler (Fig. 3).
WARNING:
Before using any attachment, read and understand the manual that came
with the attachment. Follow all safety information contained within.
WARNING:
To avoid serious personal injury and damage to the unit, shut the unit off
before removing or installing an attachment.
WARNING:
Before operating the unit, make sure the release button is fully snapped
into the primary hole and the knob is securely tightened.
WARNING:
Unless specified otherwise, the release button should be snapped into
the primary hole only. Using the wrong hole could lead to personal injury or damage to the
unit.
Summary of Contents for RS3100
Page 23: ...23 Fig 17 Fig 18 Release Button 90 Edging Hole Knob...
Page 38: ...38 NOTES...
Page 39: ...39 NOTES...
Page 40: ......