Page 7 of 12
Main Parts of Product
Part No.
Description
Qty.
Part No.
Description
Qty.
1
Hose reel
1
6
Vacuum meter
1
2
Inlet hose assembly (1/2"*2m)
1
7
Wall bracket
1
3
Oil pump
1
8
Wall bracket
1
4
Outlet hose assembly (1/2"*4)
1
9
Probes container
1
5
Suction
probes
1
10
Connector
1
Assembly Instructions
⚠
WARNING
Use only on a dry, clean, level surface capable of supporting the weight of the vehicle.
Engine exhaust contains carbon monoxide; an odorless, invisible gas that can cause injury or
death. Do not run the vehicle’s engine while using this product.
Never work under a vehicle without the proper support devices. An incorrectly supported vehicle
can tilt or fall and cause injury or death.
Do not exceed the maximum rated pressure.
Do not use the pump with water or any other liquid other than oil.
Fire hazard: flame or heat sources may ignite oil resulting in fire, injury, or death. Never use or
store this product near open flames or other heat sources.
Do not use with corrosive or flammable fluids.
Not for use by or around children.
Attach the #1 hose reel to the wall with the #7 and #8 wall brackets.
Connect the #2 inlet hose assembly to the #1 hose reel suction.
Attach the #3 oil pump to the #7 wall bracket.
Install the #6 vacuum meter at the side of the #3 oil pump (holes).
Connect the #2 inlet hose assembly to the #3 oil pump bottom hitch.
Attach the #10 connector to the #1 hose reel outlet port.
Attach the #4 outlet hose assembly to the #1 hose reel draining position.
Before Each Use
⚠
WARNING
Always wear the proper personal protective gear including ANSI Z87.1 compliant safety goggles
and heat-resistant rubber gloves when using this product.
