Page
2
of
7
INSTALLATION PROCEDURE
1
3. Using three (3) clamps per side attach the rail to the bed, position the clamps adjacent to each of the black
adjust the rail as the outer clamps are attached)
4. Tighten the clamps using a 1/2” socket. Install the bulkhead seal to the top of the front rail of the truck bed
and cut to length.
Warning!
Do not overtighten the clamp
assembly. A torque wrench is not necessary. If
preferred, torque is apx 120 inch lbs.
Warning!
Clamps must be checked periodi-
cally for tightness. Failure to do so could
result in damage to you or your property.
4
1/2”
will go t
3
Stick each one of the rubber filler strips to the bed rail, adjacent to each rail spacer (black piece with
'clamp' written on it), prior to installing the mounting rail. Tip: Lay the cover mounting rail on top of the
truck bed rail, drain tube towards the cab, to help indicate position of the filler strips. The filler strips
should be mounted on the lower portion of the bed rail. On the front (cab) spacer, two spacers will be
used on either side of the metal stamping.
2
