b. Remove the safety screw from the battery compartment cover from the inside of the door.
c. Remove the cover from the battery compartment.
d. Remove the old batteries.
e. Insert new batteries (alkaline) - pay attention to the correct polarity.
f.
Close the battery compartment.
ATTENTION
after a battery change, the stored codes (master code, guest code) and the RFID- cards
remain saved.
5. CHANGING THE MASTER CODE
(The master code you have set will be saved when the battery
is changed)
a. With the door open and unlocked, press the "CLEAR" key twice.
b. The display will show "PRGO".
c. Enter the current master code (at delivery it is 8-8-8-8-8-8).
d. The display shows "NEU".
e. Enter the desired master code (6 digits).
f.
The display will show "AGAIN".
g. Repeat the desired master code (6 digits).
h. If "dONE" appears on the display, the master code is successfully changed.
ATTENTION
If the "ERROR" message appears on the display during the opening, re-start the
process from point 5.a.
6. OPENING WITH THE MASTER CODE
a. Enter the current master code (at delivery 8-8-8-8-8-8).
b. During the opening process the "OPEN" message appears on the display.
c. After opening, the "OPENEd" message appears on the display.
ATTENTION
If the "ERROR" message appears on the display during the opening, start the opening
process using the master code you have previously set (see point 6.a).
7. CLOSING THE SAFE USING THE GUEST CODE
a. Close the door and enter the desired guest code (three to six digits).
b. The entered code is shown on the display.
c. Confirm the entry by pressing the "LOCK" key.
d. The safe is automatically locked and the display shows "CLOSE".
e. After closing correctly, the display shows "CLOSEd" and the code that you selected is
displayed on the screen.
f.
If the safe is not correctly closed the message"ERROR2" appears on the display.
g. Make sure that the door is completely closed and start again the closing process as described
at point 7.a.
8. OPENING THE SAFE USING THE GUEST CODE
a. With the door closed or the bolt mechanism extended, enter the guest code that you
previously set (three, four, five or six digits).
b. During the opening process the "OPEN" message appears on the display.
c. After opening, "OPENEd" appears on the display.
ATTENTION
If the "ERROR" message appears on the display during the opening , start the opening
process using the master code you have previously set (see point 8.a.)
9. CLOSING THE SAFE USING THE RFID ENABLED CARD
a. Close the door and hold an RFID enabled card on the RFID symbol situated on the right of
the keyboard.
b. The safe is automatically locked and the display shows "CLOSE".
c. After closing correctly, the display shows "CLOSEd".
d. If a correct closing is not possible, the message "ERROR2" appears on the display.
e. Make sure that the door is completely closed and start again the closing process following the
instructions from the point 9.a.
