Rottler Manualmatic SG8MTS, Operation And Maintenance Manual

Page: 21 / 109

Section 2 Installation SG8MTS Manual
www.rottlermfg.com
2-10
Power Supply
This machine has the following power requirements:
• 208 to 240 VAC
• Single Phase Power
• 50 or 60 Hz
• 15 Amps
See illustration below for correct connection of incoming power. Measured power at the machine’s
main breaker must be within the required range listed above. If incoming power is not within range, a
transformer must be used. Failure to do so will cause the machine to function abnormally and cause
permanent damage to the electronic control system.
Some electrical services contain a “Hot Leg, High Leg, or Wild Leg”, where single phase is derived from a
three phase connection and one leg measures 208VAC to Ground instead of 120VAC. It is not permitted
to use the “Hot Leg” for providing power to this machine. Voltage measured between the phases must be
between 208VAC and 240VAC, while each phase to ground must be ~120VAC.
Electrically connect in accordance with national and local electrical
codes.
Do not attempt to connect more 240VAC to this machine.
Do not attempt to connect to Three Phase Power.