Rottler F103 Series, Installation Manual, Operation And Maintenance Manual

Page: 59 / 318

Section 4 Control Definitions F103/4/5A Manual
www.rottlermfg.com
4-5
Mode Select
This is the right section of the screen. This is where you create or select operations to be performed on
the selected Block. This area will be blank when you first create a block.
You can create only certain modes you will use on a block or use a standard set up that inserts all modes
available. You can also create a new mode and rename if for a specific use.
New
Pressing this button will bring up a dialog box with Rottler standard operations.
Select the operation you want to create and then press OK. This will place a general Bore operation
under the Cylinder bore mode in the right hand section.
To enter General Bore mode highlight it and then press Select. This will take you to the operation screens
that will be described later.