Rottler F103 Series, Installation Manual, Operation And Maintenance Manual

Page: 156 / 318

Section 5 Operating Instructions F103/4/5A Manual
www.rottlermfg.com
5-69
Copy Lowest Copy Highest
These buttons will be discussed in the Mill Probing section of this Chapter.
4th Axis Angles
Left Bank Angle
Enter the angle of the Left Deck. This is the angle of the block in reference to the Cam and Crank bore
being lined up Vertically.
Right Bank Angle
Enter the angle of the Right Deck. This is the angle of the block in reference to the Cam and Crank bore
being lined up Vertically.
Rollover Vertical Clearance
Enter the value the Fly Cutter will have to move up vertically to clear the block when it rolls over from
bank to bank.
In/Out Offset
This is a value that can be entered to center the fly cutter in the middle of the deck. You In/Out center on
the Left bank will not be the center of the In/out on the Right bank. Enter the value the In/Out will need to
be moved to center on the Right Bank when it rolls over.
Rough Settings
These values are used when taking multiple passes on a work piece. These values can be wet high to
remove material quickly. The finish on the work piece does not matter in these settings. There will be a
Final pass that will apply the finish to the work piece.
Rough Feed Rate
Enter the desired Roughing Feed Rate;
Rough Spindle RPM
Enter the Desired Roughing Spindle RPM.
Finish Cut Settings
These values will be used for the last pass the machine will make on the work piece. These will
determine the finish left on the work piece.
Finish Amount
Enter the amount to be removed on the last pass.
Finish Feed Rate
Enter the desired Finish Feed Rate.
Finish RPM
Enter the desired Finish Spindle RPM.
NOTE: You do not need to have evenly divisible numbers in these sections. The computer will do
the math to remove the correct amount each time and for the final pass to be at the amount you
set.