4
Generously tin the tip of your soldering iron, until you get a small blob of solder.
Holding the soldering iron with tip pointing down straight, slowly lower it so that the tip is in
between the pads of the PDB and minimOSD. You want the blob of solder to touch both the solder
on the PDB and OSD, forming a bridge between them. Carefully raising the tip so that the ‘solder
bridge’ stay intact.
Alternatively
, use a small piece of stripped wire to bridge these connections.
The end the result should look like the photo on the right
**NOTE**: If you are using this PDB without the micro minimOSD, you will have to manually
bridge the video signal pads between the camera output and VTX input as shown below